Back to MarineTraffic

Vessel Movement Status Changes

This type of notifications informs you the moment any of the vessels of your interest changes movement status. You are able to choose from the following:

Stopped: Get notified when a vessel, that was previously moving, reports speed equal to or lower than 0.5 knots. This notification will remain inactive while the subject vessel is in a port or an anchorage.

Underway: Get notified when a vessel, that was previously stopped, reports speed higher than 3.5 knots. This notification will remain inactive while the subject vessel is in a port or an anchorage

Changed Course: Get notified when a vessel changes her course by certain degrees. Degrees is a parameterised variable which you can define according to your wish. For example, if you set the degrees to 60°, you will be informed in case the respective vessel changes her course by 60 degrees or more. Accepted values for the degrees variable are 30° to 180°.

Speed over maximum: Enable this notification to be informed in near real-time when a vessel's speed exceeds the speed threshold that you have defined. Keep in mind, that a follow-up notification will also get generated when the vessel's speed drops again below the defined speed limit. This notification can be applied to any vessel/fleet/specific shiptype/shipsize or to any port/area (standard or custom) or to any combination of the above.

Speed below minimum: Using this notification, you can get notified when a vessel's speed drops below the minimum speed threshold that you have defined. You will also receive a follow-up notification when the vessel's speed returns above the defined limit. This notification can be applied to any vessel/fleet/specific shiptype/shipsize or to any port/area (standard or custom) or to any combination of the above.

Was this article helpful?
4 out of 6 found this helpful
Have more questions? Submit a request

Comments

Powered by Zendesk