COMAR SLR350Ni Wifi?

Comments

4 comments

  • Avatar
    Gilles Gilles
    Hello,
    The easiest way is to buy a CAT 6a S / FTP category Ethernet cable,
    with this cable you can go up to 100 meters in length.

    https://www.cdiscount.com/informatique/composants-informatiques/duronic-cable-ftp-ethernet-cat6a-100-m-noir-prem/f-107130602-dur5060184206136.html?idOffre=55627282#mpos=4|mp

    https://www.amazon.fr/Duronic-CAT6a-50-noir-Connecteurs/dp/B00KY17NK0

    Best regards I remain at your disposal if necessary.
    0
    Comment actions Permalink
  • Avatar
    Adam Otts

    Thanks for the response Gilles.  I should have said that I am limited by the routing of the ethernet wire, not the length.  I need to get the wire from my basement to the top floor and there is no good way.  With WIFI, I could eliminate the ethernet cable and put the box much closer to the ideal location.  All of the directions say WIFI works....do you know if it really does?  

     

    0
    Comment actions Permalink
  • Avatar
    Gilles Gilles

    Hello Adam,
    No, unfortunately, I do not know the wifi for the Comar SLR350Ni.
    But be patient, an MT technician, will answer you in a few days.
    Good luck.

    Gilles

    0
    Comment actions Permalink
  • Avatar
    Robin BERNARD

    Same issue here.
    I can see the receiver connected to my router by wifi but can't access to it.
    I'm only able to reach the webUI using the wifi affected IP when the receiver is also connected through ethernet.
    I also understood from the manual that Wifi support was available on this specific model.

    Also, MT Utility never found the device, and I did all the config through web UI.
    This morning, I had an alert telling me the receiver was offline. I can see it connected on my router nut I can't reach the webUI, either through ethernet or wifi (I tried rebooting the device several times)

    0
    Comment actions Permalink

Please sign in to leave a comment.